The hand made RML lamp will give you years of enjoyment if these instructions are closely followed.
The Lamp on your model uses a high quality LED (Light Emitting Diode)
LED’s are fragile components and MUST be used in conjunction with the resistor provided unless otherwise stated.


INSTRUCTIONS
Drill a hole 2.5mm then 3mm dimension in the place where the product is to be located. Carefully push the wires through the hole, check the fit and terminate (connect) under the baseboard using a suitable terminal block. Secure the product on the baseboard in accordance with your requirements.
Use your preferred model wiring from the terminal block to your control panel and include the resistor in line with the RED wire.
No guarantee is offered for the incorrect wiring of this product.